Empowering Indian businesses in the procurement ecosystem since 2012
| Tender ID | 3998387 |
|---|---|
| Organisation Name | Irrigation And Flood Control Department |
| Tender Brief | Corrigendum : Construction Of Lift Irrigation Scheme Lis Odina Under Nabard |
| Last Date For Submission | 11th May, 2026 |
| Opening Date | 12 May, 2026 |
| Document Cost | 5000.00 |
|---|---|
| EMD | 546000.00 |
| Estimated Cost | 27838500.00 |
| City | Bandipora |
|---|---|
| State | Jammu and Kashmir |
| # | Item | Qty | Units |
|---|---|---|---|
| 1 | Stage I | 1.00 | No |
| 2 | Design, Supply, installation, testing & commissioning of Vertical Turbine pump motor set of specified duty parameters with specified capacity vertical solid shaft TEFC squirrel cage induction motor of following Specifications: i) Type : Vertical Turbine, Mixed Flow Pump ii)Discharge of pump: : 30 cusec (3058 m3/hr) iii)Dynamic Head: : 9.00 m iv) Speed: : 960 RPM v) Efficiency: : 82.5% vi) Fluid to be handled: : Raw Water River vii) No. of stages: Singleviii) Duty: Continuous x) Column pipe size Not less than 500mm ND xi)Sump Bed Level : 91.00 m xii) Minimum Water Level : 93.00 m xiii) Machine Floor Level : 100.285 m xiv) Location of Discharge Elbow : Below Machine Floor Level Material of construction Casing: : Cast Iron FG260 Impeller: : Stainless steel/bronze : Bowl & Suction Bell: Cast Iron FG260 Shaft/Shaft coupling: AISI 410 Stainless Steel Shaft Sleeve: AISI 410 Stainless Steel Column Pipe: MS ERW Base Plate: MS Suction Strainer: SS Motor specifications: i)Rating of motor: Suitable for above pump parameters. ii)Frequency: 50 Hz +_3% iii)Phase 03 iv)Voltage: 415 10% v)Efficiency: IE2 vi) RPM: 960 vii) Insulation Class: F or above vii) Enclosure: TEFC The Job includes fabrication and fitting of foundation out of requisite ISMB beams, channels and chequered plate as per site requiremnets for fixing of sole plate etc and commissioning at site and the testing on full load. Note :if not visibile properly please go to tender document | 2.00 | No |
| 3 | Fabrication,Providing and fitting of MS Pipe for rising main of Size 800mm (probable Dia) of thickeness 7 mm to be connected with the delivery side of pump (45Mtr), The Job includes fab of Y Junction, Increaser with requisite flange to connect the pump outlets with the 800 mm dia Rising main and the pipes are connecting by end to end welding up to delivery chamber. . The job also includes fabrication of bends and offsets as per the site requirement/land profile and painting of Y Junction and rising main in two coats of metal primer and synthetic paint. | 6273.00 | mm |
| 4 | Design Supply installation testing and commissio 05 Ton EOHT Crane to be installed inside the pump house. The job further includes providing/Fitting of other allied support Includes ISMB400 for Bridge Girder,ISMB250 for supporting rails, channels,32mm Sq.bar for traveling of end carriages,End carriages and gear and puppy system for providing different directions of the gantry. The job further includes providing of U clamps , Bulldogs grips etc as per requirements. the job further includesProviding and installation of 5-ton x 6 m lift heavy duty chain pully block along with monorail. Total Steel weight(1.686MT) includes ISMBeams, Channels, sq bars etc. | 1.00 | C Job |
| 5 | Voltage stabilizers: Supply, installation , testing and commissioning of 400 KVA copper wound, oil cooled , Manually operated Voltage stabilizer ( complete Oil Filled) suitable for output voltage of 415 Volt +/-1%, 3 Ph, 50 Hz, as mentioned below. The stabilizer shall function satisfactorily even if incoming supply is unbalanced between phases within range of 10%. The stabilizer should be constructed in cubical box, with bi-directional wheels for easy handling, necessary monitors and user's controls on front and user's controls on front panel such as indication, alarm, voltmeter and selector switch for measuring input and output voltage, Manual selector switch, etc. Suitable capacity termination strips and bus bars for incoming and outgoing cable should be provided. All three phases shall be independently monitored and corrected. Following protections and indications shall be incorporated over voltage / under voltage, Single Phasing Cut off contactor with electronic output sensing unit. | 1.00 | No |
8 Days Left