| 1 | Supplying, installation, testing and commissioning of booster fire pump [BP] suitable for water discharge of 450 LPM at 35-50 m head driven by electric
motor 415 volts, 3 phase 50 Hz, AC supply of 10 HP or of suitable HP capacity for manual/automatic operation and consisting of following :
(a) Horizontal/vertical type, single/multi stage, centrifugal casing pump of cast iron body & bronze/CI impeller with stainless steel shaft (SS410 grade),
mechanical seal conforming to IS 1520.
(b) Squirrel cage induction motor, TEFC, synchronous speed 3000 RPM, suitable for operation with IP 55 protection for enclosure, horizontal foot mounted type with Class-'F' insulation, conforming to IS-325.
(c) M.S. fabricated common base plate, coupling, coupling guard, foundation bolts etc. as required.
(d) Erected on provided suitable size cement concrete foundation duly plastered with anti vibration pads with perfect aligning, proper levelling complete pump set with accessories duly painted with two coats of synthetic enamel paint of fire red colour over a coat of primer (ISC code 536 as per IS 2932 of 2003) complete, as per specification no. FF-MFP/BP | 1.00 | each |
| 2 | Supplying, erecting, testing & commissioning of fire pump control panel (FCP) of cubical construction, floor mounted type, fabricated from minimum 2
mm thick CRCA sheet, compartmentalised with hinged lockable doors, with enclosure protection class IP54, duly powder coated or painted with accessories duly painted with two coats of synthetic enamel paint of fire red colour over a coat of primer (ISC code 536 as per IS 2932 of 2003), cable alley, interconnection with suitable size solid copper busbar strip of adequate size for all power connections having switchgears and accessories, mountings and internal wiring with adequate size copper conductor cable, earth terminals, numbering etc. complete in all respect, suitable for satisfactory operation of Booster pump with necessary accessories, wiring & cabling along with allied accessories with following incoming and outgoings, suitable for automatic & manual operation on 415V, 3 phase, 50Hz ac supply. INCOMER: Specified Ampere TPN MCCB 32KA with spare feeder, Voltmeter & Ammeter with selector switch, 3 phase indicating lamp, and Set of AL bus bar Amps. OUTGOING: Specified AmpereS TP&N MCCB fully automatic SOFT STARTER with over load protection, current sensing type single phase preventor, Indication lamp with ON/OFF push buttons complete with all accessories and internal wiring required for automatic operation, selector switch for local/remote, auto/manual/ OFF operation | 1.00 | eaqch |
| 3 | Supply, Fabrication, Erection, Testing and commissioning of following sizes of G.I. ERW C class pipes (conforming to IS -1239),Erection on Above Ground (including proper iron supports and anchor fastners) and Laying with all fittings (standard MS fitting with welded joint shall be used on the pipes) including tees, elbows, reducers, union, flanges, rubber gaskets, GI nuts bolts . Washer, tie bolt supports and clamps etc with one coat of redoxide primer and one coats of synthetic enamel paint. 100 mm | 30.00 | meter |
| 4 | Supply, Fabrication, Erection, Testing and commissioning of following sizes of G.I. ERW C class pipes (conforming to IS -1239),Erection on Above Ground (including proper iron supports and anchor fastners) and Laying with all fittings (standard MS fitting with welded joint shall be used on the pipes) including tees, elbows, reducers, union, flanges, rubber gaskets, GI nuts bolts . Washer, tie bolt supports and clamps etc with one coat of redoxide primer and one coats of synthetic enamel paint. 25 mm | 10.00 | meter |
| 5 | Supply, Installation Testing and Commissioning of following size cast iron double flange Butterfly Valve with matching flange, nut bolts & gasket. 100 mm | 4.00 | each |
