Empowering Indian businesses in the procurement ecosystem since 2012
| Tender ID | 4450532 |
|---|---|
| Organisation Name | Military Engineer Services |
| Tender Brief | Repair/maintenance Of Dg Sets Of Various Capacities And Allied System Installed And Repair/maintenance Of Highmast Lights, Streetlights And Other Connected Items At Water Supply Installations Under Ge (u) Udhampur |
| Last Date For Submission | 19th Jun, 2026 |
| Opening Date | 22 Jun, 2026 |
| Document Cost | 500.00 |
|---|---|
| EMD | 99960.00 |
| Estimated Cost | 4998000.00 |
| City | Udhampur |
|---|---|
| State | Jammu and Kashmir |
| # | Item | Qty | Units |
|---|---|---|---|
| 1 | Servicing of diesel engine generating set of capacity 500 KVA/600KVA of any make, including the following works are as under: - (a) Servicing of Engine (i) Re-greasing all grease points. (ii) Tighten the nuts, bolts of pipe lines of fuel oil, lubricating oil, water and check for leakages and examine the all main connections. (iii) Check water/coolant level in radiator. (iv) Check crank case oil level. (v) Clean/replaced lubrication oil filters. (vi) Clean/replaced air filters. (vii) Check that lubricating oil contains no water. Examine lubricating oil and renew if needed (viii) Check tappet clearance and all nuts for tightness. (ix) Wash felt pads of fuel filter. (x) Drain air receiver. (xi) Grease valve stems. (xii) Check all wiring, battery water level, gravity of battery, inspect all bushes and bush holder, cleaning of surface of commutators. (b) Servicing of alternators (i) Check temp rise of bearings. (ii) Check bushes on exciter commutator and the alternator slip rings run without chattering or sparking. (iii) Check if bushes freely slide in holder and whether bush springs are in order. | 5.00 | Each Job |
| 2 | (iv) Check if oil rings are freely rotating in the bearings. (v) Check oil level in bearings. (vi) Wipe clean the alternator and exciter. (vii) Check all wiring and rectify any defect with new wiring. (viii) Surface and clean the commutator. (ix) Take insulation and earth test on alternator and exciter and if defective investigate cause and remedy. (x) Check joints, clamping and bolting in all the wiring including control panels and rectify any defects. (xi) Check greases in all roller and ball bearings and make up if inadequate. (xii) Check the degree of wear of commutator bushes and renew if necessary. (xiii) Tighten all nuts in the rotors of alternator and exciter. (xiv) Check air gaps between starters and rotors and clean off any projections on the rotor. (C) Clean the complete bottom inner/outer side up to floor level carried out with kerosene. all accessible associated internal parts were also cleaned throughly with kerosene to the maximum ossible extent. Note for item No. 1 to 4 : Items to be replaced will be measured and paid separately, as supply only and labour for fixing deemed to be include as part of servicing. | ||
| 3 | Description all as per Ser item No 1.00 here- in- before, but 250 KVA to 320 KVA as per existing Mak, Complete all as specified and directed by Engr-in-Charge. | 7.00 | Each Job |
| 4 | Description all as per Ser item No 1.00 here- in- before, but 200 KVA as per existing Make. Complete all as specified and directed by Engr-in-Charge. | 2.00 | Each Job |
| 5 | Description all as per Ser item No 1.00 here- in- before, but 40 KVA to 100 KVA as per existing Make. complete all as specified and directed by Engr-in-Charge. | 9.00 | Each Job |
19 Days Left